You have to remove the dash trim. You remove the thermostat cover which exposes the thermostat gasket and thermostat. The radio should just slide out. I believe the back defogger grid is the radio antenna. I will give you directions for a 2v first.
Of course, this means you'll need to remove the original stereo from the dash. Fortunately for Protege owners, this is an easy task. You don't have to remove all the stuff mentioned in the instructions. Remove 1 phillips screw from the panel. One of the most time consuming tasks with installing an after market car stereo, car radio, satellite radio, xm radio, car speakers, tweeters, car subwoofer, crossovers, audio equalizer, car amplifier, mobile amp, car amplifier, mp3 player, ipod or any car audio electronics is identifying the correct color car audio wires for your 2002 Mazda Protege.
Note the bolt has reverse threads for the crankshaft pulley and the pulley and bolt are one piece molded together. How to remove the alternator from a Protege 2002. Many audio enthusiasts want to improve upon the factory gear, and changing the car's original stereo to a higher-performance and more powerful aftermarket stereo is one of the best ways to start the process. Yours should be one piece including the trim around the radio. Go in from underneath and take to finish the rest of the job.
Do this carefully to not lose or break the little nylon sleeve. Alternatively, you can make U-shaped tools out of lengths of still coat hanger. If you do not time it properly you will damage the engine. As though a wire has come loose, I pulled the deck out to see if there was anything that had come loose and there was nothing. I found this the hardest pice to get back on. When you pull it, it shows 20C and 65C at the botoom of the dipstcik, min and max in cold and hot depends on the engine temperat … ure. Defective ra … diator cap? Once in place tighten the set belt and hinge bolt.
Unsnap the top edge of the knee bolster panel. Always verify all wires, wire colors and diagrams before applying any information found here to your 2002 Mazda Protege. Once you know how it to do it, is should only time a few seconds Remove the cruise control diaphragm and take it out of the way to gain access from the top. They are about half and inch wide; just jiggle and pry them out. Once you put the new bulb in, just close the cage and re-hook the latch. Alternator belt tension adjuster bolt C —Protégé 2.
The next and last is a vinyl covered screw visible in the upper right of panel. Remove plug from upper rear side of door. The Mazda radio on a 2002 protege comes out just like the Ford radios. You will need two of the U shaped tools, one for either side of the radio. I really hope help you with this remember rated this help Good luck. It will move just a big but not enough to get it out. Then peek arount he edges of the panel to pop out or pry out the nylon plugs that anchor the panel to the door.
You must disconnect the negative battery cable. Insert them until you hear a click, then push the left one to the left and the right one to the right. Unsnap and remove dash bezel. I just found out that there is a consistent issue with Protoges and aftermarket alternator belts and proper fit. Good luck with your 2002 Mazda Protege radio troubleshooting. Tighten the bolts to 18-22 ft.
The next is found when you pop off the soft vinyl arm rest starting from the back. I loosened all the hoses and pushed them out of the way but still not enough room. Back seat, sail trim and package shelf had to be removed to access upper strut mount. Tighten the nut to 72 inch lbs. Use of the Mazda Protege wiring information is at your own risk. This will depress the clips that hold the radio in.