Using a fuse with a higher amperage rating can cause severe wire damage and could start a fire. By the mid-1990s, Ford had converted what was once a vehicle only found on job sites and farms, to a vehicle that was being used as a family car. Once all the bell housing bolts are removed the transmission will sit in place on two alignment posts. In the event that there are still programming difficulties, contact HomeLink at www. Connect the other end of the positive + cable to the positive + terminal of the assisting battery. It shifts hard when you drive normal or put it to the floor, floor from 1st - 2nd but the problem is not as noticeable when you drive it like your grampa. It should separate from the engine easily.
Remove bolts holding tranny to bell housing. Her speedo tweaks out after it goes above 50 mph. It's under the dust cap. If the battery has been disconnected and reconnected, refer to the Battery section of the Maintenance and Specifications chapter. Carry out transmission backflushing and cleaning.
Ford Motor Company has not approved a slingbelt towing procedure. After the cross member is out and the transmission is supported, crack every bolt but don't take them out. Make sure you jack it up on completely level ground. There should be no more than one inch of movement for proper installation. The 4R70W transmission was first used in a production vehicle back in 1993 and remained an optional transmission through the 2004 model year. If you have an electronic 4x4 then there is one more plug. Mark the driveshaft flange and pinion flange for correct alignment during installation.
If transmission disassembly is required, drain the transmission fluid. Rotate seat cushion up until it locks into vertical storage position. Fuel ethanol and gasoline may contain benzene, which is a cancer-causing agent. The BeltMinder feature is activated and the vehicle speed is less than 3 mph. If the fuse is not blown, perform the following procedure: 1.
On vehicles equipped with the 4. Do not fully tighten the lug nuts until the wheel has been lowered. By - May 23, 2016 This article applies to the Ford F-150 1988-2008. Refer to the Maintenance product specifications and capacities section in this chapter. Make sure all the wires are disconnected from each side. Gently pull on the cover to make sure it is seated properly.
Just look at the transmission and see what needs to come off. Press and release this control to decrease the vehicle set speed in small amounts by 1 mph 1. Check the fuel filler cap for proper installation. Ford Motor Company shall not be responsible for any such programming changes. Set the parking brake and shift to P Park. Get several friends like at least 4 , remove fuel tank holes the allow you to fuel truck and lift slowly anf det bed on saw horses. Here is a quick step by step guide for removing your 4R70W transmission from your Ford F150 pickup truck two wheel drive version only.
Adjust the temperature control to maintain comfort. Repeat this procedure for another remote transmitter if desired. Check with your authorized dealer for availability. Octane recommendations Do not be concerned if your engine sometimes knocks lightly. Attach the new wiper to the wiper arm and press it into place until a click is heard. One is to drop the fuel tank and clean the dirt from around the fuel pump and take a screw driver and nock the ring around as it unscrews. This article applies to the Ford F-150.
Raise front and put jack stands to give you some room to work. Jack up your truck and safely support using jack stands! Refer to the payload description and graphic in the Vehicle loading — with and without a trailer section. Lift tailgate to a 80—degree angle from horizontal. Improper use of the power outlet can cause damage not covered by your warranty. On the passenger side of the vehicle you need to gain access to the transmission.